Previously I posted on here about an issue with my Varla Pegasus rear rotor. Ordered a new rotor, replaced it, good as new. Took it out for a ride, and the front tire started making a rattling noise.
Realized it was the metal piece that holds the brake in place, looked like the screws were loose. Took it home, removed the front wheel, went to tighten the screws, and the head of one of the screws fell out.
The screw broke and the rest of it is lodged inside the metal. I have no idea what to do at this point. And advice would be much appreciated. I just want to ride my scooter. 🥲
There are a few options, depending on how handy you are.
Here’s a video that lists 7 ways. I’m betting #5 will be one.of your better options here.
In the past, I’ve drilled a skinny hole into what’s left of the screw, then lightly tapped the short end of an Allen/hex key into it. The key here is to not make the hole so tight for the key that you’ll never be able to pull it off after you’ve extracted it. But there are other ways of getting the junk screw off the key if it came down to it.
Check your local hardware store or specialty auto shop (eg, AutoZone) for a screw extractor kit. Be sure the kit comes with a small enough bit that would fit into a hole you’ve drilled into what’s left of the broken screw. (This is option #5 in the video, btw.)
The OP of that won’t see your reply as he posted that on Reddit, and our crossposting bot crossposted it here for spur discussion here. So, despite the OP on Reddit not being here, I’m glad you commented as that’s a fairly common issue and lot’s of folks can benefit from this info. Thanks for the info!
Ah good stuff, good to know, thanks!
