I can’t even figure out how to tell if it’s supported or not. If it is supported, I can’t figure out how to enable it. If it is enabled, idk where I should be seeing it in proxmox!

Can anyone point me in the right direction?

  • wildbus8979English
    2·
    8 months ago

    You should be good to go. Make sure vfio is loaded in the modules-load.d

    vfio
vfio_iommu_type1
vfio_pci
vfio_virqfd

    Make sure the module options are set correctly and the kernel module is blacklisted in /etc/modprobe.d/vfio.conf

    options vfio-pci ids=1000:0097
blacklist MODULE_NAME

    Make sure.IOMMU is enabled in your kernel command line (ex via grub): intel_iommu=on iommu=pt

    This is probably not complete, but it should get you pretty far into allowing you to add the pci device in the hardware config of your vm