I am in the process of attempting to install an outside switch for a radon mitigation system. However, I am unable to drill through the remaining part of the block wall. I have an M12 Fuel hammer drill and a carbide drill bit. I imagine something is in the way but what? If it was concrete in the floor I would guess rebar. The first part went through like butter. I have pictures: https://imgur.com/a/hCed4u8

  • CountVon
    link
    fedilink
    English
    arrow-up
    6
    ·
    2 months ago

    If it was concrete in the floor I would guess rebar

    Rebar is used in hollow block wall too:

    I’d remove one of those circular knockouts at the back of the wall box to drill an inch to the left or right.

      • ballskicker
        link
        fedilink
        English
        arrow-up
        1
        ·
        2 months ago

        Judging by how far it looks like your bit drilled through the wall it could also be that you were just having the absolute worst luck and managed to find a brick tie on your first attempt. If that’s the case then the good news is that you shouldn’t have a hard time avoiding them if you stay around the area you’ve already drilled into.