I’ve been using gyroid infil almost exclusively since I first tried it.

I was using cubic before, which was fine, but gyroid seems much sturdier for the same % infil even if it does take a bit more print time.

Also it looks awesome.

  • newIdentity
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    You could also just use a lower infill percentage since it’s stronger

    • Jtskywalker@lemm.eeOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      There’s a type of cubic that starts out lower and increases in density as it reaches the top to support the top layers. That’s mainly the one I was thinking of. I can’t remember the name of it though. And lightning is suuuper fast but provides basically no strength