I was doing some bike maintenance today and wanted to disassemble my rear hub. It turned out that I needed a 12mm Allen bit for that, which I don’t have. So I 3D printed one! And it worked! Torques safely to 5Nm and I only needed 4Nm for the job. Haven’t tested higher torques.

  • ImgonnatrythisEnglish
    2·
    1 year ago

    A 3d printed caliper is not a bad idea, but the shape isn’t always great for working on cars and bikes. A vertical telescope mimics the approach of the tool. Its something trivial enough I would probably never buy it, but might print it.

    • Glemek@lemmy.worldEnglish
      1·
      1 year ago

      You could use a divider caliper to be able to translate the size of a fastener to a spot that is easier to measure, if you don’t have to swap between inches and metric it would probably be easy to be accurate enough with it without much practice.