@[email protected] to No Stupid [email protected] • 6 months agoIs PLA a good material for 3D printing a tool intended to remove pack ice from a driveway?message-square8fedilinkarrow-up19arrow-down12
arrow-up17arrow-down1message-squareIs PLA a good material for 3D printing a tool intended to remove pack ice from a driveway?@[email protected] to No Stupid [email protected] • 6 months agomessage-square8fedilink
minus-square@[email protected]OPlinkfedilink1•6 months agoI was thinking something like a chisel, but yeah, these comments suggest even that would break before the ice.
I was thinking something like a chisel, but yeah, these comments suggest even that would break before the ice.
Try salt?