• pete_the_cat@lemmy.world
    link
    fedilink
    English
    arrow-up
    7
    arrow-down
    26
    ·
    11 months ago

    You still need to get that electric from somewhere and like half the country still runs on either coal or oil.

    Earlier this year I saw that NY State is outlawing gas stoves and gas and oil (hot water) heaters in new residences. The funny thing is that NY State gets over 50% of its energy from oil fired energy plants. So instead of smaller places using gas and oil maybe a few times a day, they’re going to be putting increased loads on an already stressed system (at least in the case of NYC, where this is largely targeted since it contains a good amount of the state’s population). They’re not really helping anything.

    • nikita
      link
      fedilink
      arrow-up
      27
      arrow-down
      1
      ·
      11 months ago

      Electric appliances are generally more efficient than appliances powered directly by non renewable sources though. And a single oil/gas powerplant is probably more energy efficient than thousands of individually gas and oil powered appliances. So just changing to electric appliances will already reduce emissions.

      And it sets the city up to upgrade to renewable energy in the future.

      • evranch@lemmy.ca
        link
        fedilink
        arrow-up
        9
        arrow-down
        9
        ·
        11 months ago

        Sadly, no. Your electric heater is 100% efficient, yes, but that thermal power plant is lucky to hit 50%, especially if it’s old tech which many are.

        On the other hand, burning natural gas at the point of use can be done at 95% efficiency by a condensing boiler or furnace.

        That’s not even taking into account transmission losses. With them in play, even a ground-source heat pump has higher emissions than a natural gas furnace.

        The only way electrification of heating makes sense is to decarbonise the grid, which should be the first priority. Nuclear and hydro baseload with solar/wind peaking and elastic loads and load shedding to take advantage of the variable supply.

        • AA5B@lemmy.world
          link
          fedilink
          arrow-up
          7
          ·
          edit-2
          11 months ago
          1. You can’t complain about electricity loses without considering natural gas losses, especially the affect of methane on global warming
          2. Why would you have to do one thing, then the other? Everyone agrees we need to both electrify homes and de carbonize the grid. However we also realize both are a long complex, expensive transition with many many pieces. It only makes sense to do both at the same time: an electrified house already reduces its impact on global warming, and just keeps getting better over time as the grid continues to be de-carbonized
        • ratman150
          link
          fedilink
          arrow-up
          6
          ·
          11 months ago

          Since we’re talking efficiency I’m sure you also know that several smaller consumers are gonna be far less efficient than one big consumer.

          I’m not sure where you’re getting that information about a heat pump being worse than a literal fire burning furnace but that fire burning furnace is still less efficient as a small appliance than the power generation. What’s also important here is the heat pump can run on natural gas electricity, nuclear electricity, hydro etc. it is energy agnostic which the furnace is absolutely not.

          • evranch@lemmy.ca
            link
            fedilink
            arrow-up
            2
            arrow-down
            4
            ·
            11 months ago

            several smaller consumers are gonna be far less efficient than one big consumer

            That’s the point I’m making. It’s counterintuitive. They are actually far more efficient, even though that “feels wrong”.

            Thermal power generation is limited by the Rankine cycle https://en.m.wikipedia.org/wiki/Rankine_cycle with a MAXIMUM efficiency of only 42%.

            You are burning fuel, turning a temperature differential into motion, into electricity, transmitting the electricity, then turning it back into a temperature differential.

            In the specific application of heating, it makes far more sense to burn the fuel on site, where you are running at far lower temperatures and capable of condensing the exhaust to hit 95% efficiency.

            I’ve worked with heat pumps, even built my own custom unit and I know that with the right refrigerants, low temperature distribution and oversized ground loops you can hit as high as a COP of 7. But the average affordable crappy air sourced unit is more like 2-3 and in a Canadian winter will not function at all, falling back on resistive heating at COP 1. And let’s face it, nobody has $20-50k for an amazing oversized ground sourced system and a rework to hydronic floors. They’re buying a reversible mini-split, DIY installing it and being disappointed when their heating bill goes up.

            So with a COP of 2 and a power plant efficiency below 50% you are not even back to where you started if you were just burning the fuel in a furnace. And that’s best case, perfect conditions at the plant, no transmission losses, warm day, no Iosses in the heat pump.

            It gets worse if your power comes from burning coal like ours does.

            I’m just saying there’s no perfect drop-in solution, you can’t just handwave heat pumps in as a magic problem solver. In many cases there are bigger gains to be had from efficient furnaces than a massive electrification program, at least in the short to mid term.

            • nikita
              link
              fedilink
              arrow-up
              5
              ·
              11 months ago

              Thanks for your comment. Very informative and insightful.

              However, your argument only works when electricity is sourced from 100% non renewable sources. If your city power uses some hydro, nuclear or other renewable sources, the efficiency of electric appliances goes up and will likely be at least comparable with the average gas powered home appliance. And it will keep going up as power plants become renewable and thermal plants are decomissioned.

      • pete_the_cat@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        arrow-down
        3
        ·
        11 months ago

        We should be moving away from gas and oil entirely instead of just saying “no one can install these in your homes anymore”, it’s just shifting the load.

        • AA5B@lemmy.world
          link
          fedilink
          arrow-up
          8
          ·
          edit-2
          11 months ago

          If you insist on waiting for that magical “silver bullet” That will fix everything with no downside, you’re not getting anywhere. You’ll never improv. Things will never get better. You’re frozen in over-thinking.

          “No more new gas hookups” is a tiny step forward. By itself, not too significant and would take over a century to have an impact. Nevertheless, it is a step forward. As we talked more such steps, we’ll be able to move right along

          You could also argue “no new gas hookups” as a consumer protection thing, whatever is the consumer of that. You’re saying that we don’t expect the new infrastructure to be productive long enough to justify the cost

          Then there’s the medical impact, at least for inside appliances. You may try to argue it but the best medical knowledge has a strong correlation of childhood asthma and other lung problems with indoor gas appliances.

          • pete_the_cat@lemmy.world
            link
            fedilink
            English
            arrow-up
            1
            ·
            11 months ago

            The problem is “public health” vs “private funding from businesses with interest” and we know the latter almost always wins. It’s two steps forward and one step back, which is still progress, but self defeating progress.

        • Maggoty@lemmy.world
          link
          fedilink
          arrow-up
          4
          ·
          11 months ago

          That’s never been how technology shift or legislation works though. Everything comes in phases.

          • pete_the_cat@lemmy.world
            link
            fedilink
            English
            arrow-up
            1
            arrow-down
            1
            ·
            11 months ago

            True, but we both know that the oil and gas industry has a stranglehold on the US in pretty much every way, shape, or form. It seems like this is just another “look we’re doing something good for the environment!” when in reality it’s just “theater”.

    • Rusticus@lemmy.world
      link
      fedilink
      English
      arrow-up
      11
      arrow-down
      3
      ·
      11 months ago

      You probably don’t know that having a gas stove in your house is the benzene/cancer equivalent of a cigarette smoker sitting in your fucking kitchen blowing smoke in your face while you cook dinner.

    • Maggoty@lemmy.world
      link
      fedilink
      arrow-up
      3
      ·
      edit-2
      11 months ago

      A. That powerplant is far more efficient

      B. There’s no reason NY can’t change to renewable sources.

      • pete_the_cat@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        arrow-down
        1
        ·
        11 months ago

        The problem is that tens (or probably hundreds) of thousands of gas stoves and oil burners still exist and are used daily, this also doesn’t cover restaurants or commercial businesses, so the impact is pretty minimal.

        Your “B” suggestion is hilarious because if they wanted to they could have done it already, there are (at least) two nuclear reactors in NY State IIRC, but they have been constantly blocked at every turn from building new ones for the past few decades by the oil and gas industry. Hydroelectric plants are already in use, along with wind turbines. If it was as simple as “build renewable power plants” don’t you think we would have done that everywhere by now (where it’s feasible, obviously)?

        • Maggoty@lemmy.world
          link
          fedilink
          arrow-up
          1
          ·
          11 months ago

          So because we haven’t done it yet, we shouldn’t do it now? That’s just the inverse of we do it this way because we’ve always done it this way. Both are piss poor reasons not to change now.