I have spent weeks of tuning PETG to print on my modified CR-10. I would get regular failures and really stringy prints. I had trouble getting it to stick to the bed, and could only print really slowly.

I was dreading trying ASA, but I bought a roll of Polylite ASA, put it on the printer without drying it, and used a default ASA profile I found online (I didn’t even start with a temp tower). The only changes I made was a minimum layer fan of 10% as my PETG fan shroud needs constant cooling. I didn’t see anything about enclosure temperature so I left it at 40°.

The first print started great but broke off the bed. The Z height was off and I didn’t get it fixed until the first layer was halfway done. This benchy is the second print using a default ASA profile, no tuning.

I feel like I’ve wasted my time with PETG. This material has been so much easier to print.

Edit: not sure why my image didn’t upload. I’m new to Jerboa.

  • DarkwingDuck
    link
    fedilink
    English
    arrow-up
    1
    ·
    edit-2
    1 year ago

    Maybe slight overextrusion looking at the bow sides. Needs retraction tuning as well, looking at the smokestack.

    • Kale@lemmy.zipOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Yeah it’s not perfect, but I didn’t do any tuning at all, and I was running at a faster speed than I normally run for a warping material.