If you don’t know what lightning infill is, it was made by Cura and was added to PrusaSclicer.

I chose to print with it since it showed up as a tool tip. Hoping has the same infill strength as Gyroid as it’s suppose to use less filament (estimates is around 5 grams for this part). It was suppose to also save time, but it instead added 10 min.

  • the16bitgamer@lemmy.worldOPEnglish
    6·
    10 months ago

    I like gyroid since it doesn’t overlap itself on the same layer. So when a drippy filament is printing you don’t get random lines in the infill that can break off