I’ve tried to report the issue to Prusa support but they keeps trying to diagnose it as user error. But at this point I’m at a loss and presume that it’s either a firmware issue or a sensor issue on my unit.

Either way im very disappointed.

And before you ask, this is the opposite side

PXL_20240301_160413072

EDIT: I will note that this print sheet is ruined for my use case, since those patterns will be shown on the underside of my prints. But the print surface still works and can be used without issue… if you ignore the gouges that are being detailed into every print.

  • grayman@lemmy.worldEnglish
    2·
    10 months ago

    Stuff sticks to my pei sheet TOO well. Clean it well… Soap and water with a new clean soft sponge. Get all the glue off and any other gunk and oil. Wipe it dry with a clean towel. Lightly rub it down with isopropyl alcohol. When dry, print on it with nothing on the sheet. I can go like 20 big prints before I have to clean it again.

    • ImgonnatrythisEnglish
      2·
      10 months ago

      Yeah I’ve done all the things. Things don’t stick to mine. 1st layer issues. Gluestick works great. Others have reported this issue. I see no disadvantages to the satin sheet. Ive heard nothing but happiness with it. Seems like it should be the default from everything I’ve heard.