I have added a wifi repeater to the outside of my home so that my wife can watch her critter cams. It is a POE device that runs all the way back to my router.

Would like to install this surge protector but I’m getting conflicting information on grounding it. My installation is to the side of my house, not a metal pole.

Lowest effort options first, I can:

A. Place the protector inside near where the CAT5 enters the basement. Ground to a junction box that I installed that is grounded to the house panel and rod.

B. Ground internally to a water pipe or externally to the outdoor spigot.

C. Drive a ground rod where the cable exits the house and ground to it.

D. Repeat C and also bond to to the pre-existing home ground rod. (Least preferable option, rods would be on opposite corners of house.)