• LastYearsPumpkin@feddit.ch
    link
    fedilink
    English
    arrow-up
    23
    arrow-down
    2
    ·
    1 year ago

    If you stuffed the tube into the tire and inflated it, it might have had a small fold in it that got trapped and split.

    When you inflate the tube the first time, you should inflate it slowly and only a little bit, massage the tire to release any kinks or folds, then slowly increase pressure until about half way. Then give it another massage and deflate it. Then you can slowly refill it all the way.

    • schmidtster@lemmy.world
      link
      fedilink
      English
      arrow-up
      20
      arrow-down
      13
      ·
      edit-2
      1 year ago

      That’s unacceptable, this is a manufacturer defect and is no way caused by faulty inflation, which isn’t a thing. If it breaks, it was defective, simple as that.

      If you need to do this and this so it doesn’t break, find a better brand.

      • uniqueid198x@lemmy.dbzer0.com
        link
        fedilink
        arrow-up
        19
        ·
        1 year ago

        Its quite possible to have a pinch in the tube which will fail during inflation. In my experience, thats all brands; a tube simply can’t withstand 100 psi at a pinch point. This failure is not that, however. This is almost certainly a manufacturing defect, as metioned.

        • 𝒍𝒆𝒎𝒂𝒏𝒏@lemmy.one
          link
          fedilink
          arrow-up
          4
          ·
          1 year ago

          a tube simply can’t withstand 100 psi at a pinch point

          That explains why I kept getting punctures on my old tubes at 90psi 😮 must’ve been fitting them in a dodgy way after previous repairs

          • schmidtster@lemmy.world
            link
            fedilink
            English
            arrow-up
            6
            ·
            edit-2
            1 year ago

            Or as you said, old tubes. Lots of factors, but a good tube will work a fold out unless it’s literally pinched between the rubber and rim.

            • sugar_in_your_tea
              link
              fedilink
              arrow-up
              1
              arrow-down
              1
              ·
              1 year ago

              I recently patched my tube, and when I inflated it to 40 psi or so, I could hear popping in the tire from the pinches working their way out. And this is despite being careful by preinflating it before putting the tire back on.

              I’ve had the same with new tubes as well. Just be careful when inflating your tube after installing the tire. This particular tear probably could’ve been avoided by preinflating the tube.

        • schmidtster@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          A fold will work itself out, if you pinched it between the rubber or rim, nothing you could do would prevent it from rupturing other than reinstalling it correctly.