To achieve faster speed printing for functional and draft prints, I wanted to try a 1.0mm nozzle with my Neptune 3 Plus. This is the first time I replace a nozzle so I followed YouTube videos and replaced the nozzle. After replacing the nozzle I leveled the bed with manual + automatic leveling. The extruder seemed to be working, taking and extruding the pla filament. Success? Sure not yet .
I started fiddling with cura profiles, increased line width, layer height, temperatures for head and bed, decreased speed… Tried a few times to achieve adhesion and printing. So things looked good. After the trial and errors I was satisfied that I could print now.
I started a 1 and a half hour print. It started well and I went for some tv and started checking the video feed. Things started well, but in time some warping occurred. It was evident that the print would fail. However I wanted to see how things will end up so let it continue. Sure it ended with some spaghetti.
Everything is as expected up until now. So I returned back to stop the spaghetti. But there was a strange blob at the end of the extruded filament spagetti. And the nozzle was there?!? I am still confused how the nozzle ended up out of the extruder being intact.
Am I understanding that you found the nozzle IN the print itself? Like it unthreaded and left the heat block?
Have you tried threading another nozzle into the heat block just to see if there are still threads left?
Yes exactly this is.
After this I used a 0.8 nozzle. And could print with it. So threads are still there.
I suppose I mistakenly didn’t fully screwed the 1.0 nozzle. With the large layer width Pla stuck on the nozzle, as the print was a rectangular shape on each turn that pla applied some tork and nozzle unscrewed.
That is pretty crazy, definitely a new one on me but I think you’re right how it happened. I’ve seen a video where someone used a torque wrench to set the nozzle just right but I can’t bother with all that…