I’m certainly no expert but I understand submarines have an inner and outer hull. The inner hull has to withstand the pressure of the deep but the outer hull does not. The inner hull would be crushed into bits but the outer hull and any equipment in-between would likely be ripped into large chunks as such a violent event occurs inside of it.
Subs have dual hulls so they can fill the void between them with water to sink, or air to float, but they don’t dive anywhere near as deep. Most regular naval subs operate above 800 meters. They only have to be below the surface of the water for stealth, not at the bottom of the ocean.
This craft was a single hull design as far as I’m aware, designed with a rigid hull to try and counteract the pressure at the bottom.
Yeah, double hull might not be correct for what I’m trying to describe, as I know the Titan used ballast weights to sink rather than flooding void spaces. But in every picture I’ve seen of the thing so far, the outer layer looks like it was a sort of shroud to protect against more conventional sources of damage (read: bumping into shit). I could be entirely wrong about that, and should probably have refrained from commenting.
Interesting - I had imagined it being imploded into bits like the simulations on the news show.
I believe this is the outer portion. The carbon fiber shell imploded and is probably not recoverable.
I’m certainly no expert but I understand submarines have an inner and outer hull. The inner hull has to withstand the pressure of the deep but the outer hull does not. The inner hull would be crushed into bits but the outer hull and any equipment in-between would likely be ripped into large chunks as such a violent event occurs inside of it.
Subs have dual hulls so they can fill the void between them with water to sink, or air to float, but they don’t dive anywhere near as deep. Most regular naval subs operate above 800 meters. They only have to be below the surface of the water for stealth, not at the bottom of the ocean.
This craft was a single hull design as far as I’m aware, designed with a rigid hull to try and counteract the pressure at the bottom.
Yeah, double hull might not be correct for what I’m trying to describe, as I know the Titan used ballast weights to sink rather than flooding void spaces. But in every picture I’ve seen of the thing so far, the outer layer looks like it was a sort of shroud to protect against more conventional sources of damage (read: bumping into shit). I could be entirely wrong about that, and should probably have refrained from commenting.
The outer shell didn’t hold pressure and was there to cover wires/ equipment exposed outside the pressure vessel.
Why would you put any faith in a simulation by an organization that has no knowledge of the domain?