Hi,
I was trying to setup OPNSense with My ATT BGW320-500, and had a few questions.
Configuration Questions:
- Dupuis.xyz - this link has a FW for an older version for BGW210-700, can I use it for my BGW320-500?
- Prerequisites mentions that I need to figure out
ONT_IF,EAP_IDENTITY, andRG_ETHER, how does one do that?
Setup questions:
- Do I need the Ethernet from
ONTcable to myWANport on OPNSense box? - Step 5 in the prerequisites document asks to test, but my box doesn’t have
bashor any internet access (to install bash)? How do I do that?
Thanks.
EDIT: I’m using Fiber.
I have the same Residental Gateway. Using pfSense+ on my end. The BGW320-500 is fiber capable. I assume you’re using fiber? If so you cannot hook it into ONT because the RG is the ONT. In my case I get raw fiber into a PON module that hooks into the RG. Best you can do in this case is set the RG to “passthrough mode” via web UI (192.168.1.254).
If you have a different setup that is not fiber maybe you’ll have more luck with a bypass, but I think you will need the RG regardless for auth: https://docs.netgate.com/pfsense/en/latest/recipes/authbridge.html
Just to understand, does that create a DoubleNAT? Do you happen to know what is your latency (ping time)? Thanks a ton.