Are the following two diagrams correct for a residential cable-based ISP? I was wondering where the PoE filter goes for the second image, if at all.

  • seedbedUnmoved@lemm.ee
    link
    fedilink
    English
    arrow-up
    3
    ·
    1 year ago

    Generally speaking they look good for the ideal situation. However, it is far more common to not be able to isolate the cable modem from the MoCA network. For it to work as pictured you need two coax runs to the location of the cable modem and router. Most homes only have one run to each room. You could place the cable modem near the utility closet but that is usually a pretty bad location for an access point. Most MoCA installed end up with a single coax network and the point of entry filter on the far left.

    With regards to the point of entry filter in the second diagram: as noted in the image you do not the filter since the MoCA and CatTV network are completely isolated.

  • Spade EchoesOP
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    Sorry if this is not exactly an enterprise network post orz.

    Gotta start somewhere right?

    • seedbedUnmoved@lemm.ee
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      I’m curious what the community’s take on this is? I’m more interested in the Home Networking side of things but I’m not sure there is enough of a critical mass to have dedicated communities for both enterprise and home yet. Is it better to start together and then split as it grows?

      • Spade EchoesOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        There’s likely lessons to be learned from both sides so it may be best to keep them together in one place.