Finished this baby 6 days ago and thought i should give an update along with my other questions. Special thanks to u/original_user for pointing out my mistake (which i thought i didn’t make) and u/AL-H for further answering my question
https://youtu.be/P2HIoPjLU_c?si=9jbb-yu0dYpCbvWX
The build is still a WIP cause i’m using a very unconventional led strip to temporarily lit up the case. I’m ordering the correct type of led strips so they should arrive in a few days. Screen is still powered by the lcd psu as i don’t have a multimeter and a soldering iron yet (they are on the way home too).
On to the questions, i’m trying to power the screen via my PC psu. Which cables should i cut and keep? I don’t have a multimeter yet but luckily the cables are color-coded. However, i can’t seem to figure out what every wire does. Can someone help me?
So, i’m assuming i just have to solder/connect 2 black wires (GRD) and 2 red wires (5v) to my psu molex connector (will probably need an adapter cable?) and it should boot right up?
Appreciate any help!
it looks about as horrible as your last two posts about it made it seem
its still on floor as i dont have a proper table yet 🤣