cross-posted from: https://lemm.ee/post/1009849

I’m planning to print up a bunch of brackets to mount LED shop lights (very similar to these) to the ceiling in my garage. My plan is to use an upside-down “U” shape bracket that screws into a joist/drywall anchor in the middle and then sort of clips around the sides of the metal frame.

Maybe filament type doesn’t matter much here, but I’d rather not come out to one of the lights having fallen on my car if I can help it 😅

I think the main considerations are just temperature and stiffness. It can get up to about 85F in the garage on the hottest summer days, and probably a few degrees warmer by the ceiling. The lamps are cheap LED tubes, so the metal housing only gets slightly warm to the touch (say 90-100F or so). I know PLA is a bit stiffer at room temp, but I’m worried it might soften too much at the worst case of warm temperatures.

Any thoughts on PLA vs PETG for this situation?

  • Flaky_Fish69@kbin.social
    2·
    1 year ago

    Glass transition is usually somewhere around half the melting temp (which is usually printing temps), and that’s where things get really dicey.

    But plastics in general will always soften a bit as they get warm and PLA is known to deform over time when exposed to sunlight (especially in car interiors,).

    LEDs aren’t nearly as bad as other lights, but they can still put out enough heat they I’d worry about it across the long term.

    If it was just a temporary solution, I might not be as concerned.