White ABS is a classic
In northern hemisphere on the west coast. It doesn’t get too cold here.
I bet the browning of the leaves is just underwatering. I got lazy with watering and travel.
Either way I am hoping for Artichoke seeds for next year. They are actually quite a nice privacy plant, and apparently they are annuals.
Microcenter ABS is pretty nice. In general they do some good stuff.
Of course you run exhaust fans! I run Bambi’s with enclosures, I don’t have an exhaust fan setup yet.
I often wonder about fumes and cancer risks.
Not a direct reference of the Henry vi character
Adding in references, they are characters from Jeanne D’arc. It’s a lovely tactical rpg akin to Final fantasy tactics.
These are the main villains I believe
Liking the fine line work on this quite a bit.
I get various cartoon dog vibes from this.
Yes, I harvested 3, then left three to age on plant. They are browned and are atop the stalks.
Yes in my experience, ABS is an easier print.
For ASA, I think maybe Sainsmart. They also do bad tpu, so maybe source was the problem.
How do you handle fumes with ASA? they are much worse than ABS, imo.
Hey! I was thinking about doing this.
Any useful info, should o give it a go?
Essentially. I was growing oregano, basil, flowers, and thyme in others.
Printed right side up. Everything was achieved via support setting optimization, and heated support removal where necessary (nose and lip in particular).
PLA holds up alright, but it’s gets brittle. There are just better choices.
Interesting point about the ABS, it appears to be holding up very good, but I’ll monitor it overtime.
ABS is nice, PETG good, ASA hard to print, PLA holds up(but don’t recommend).
I like the hatching a bit. The grey paper and ink choices are good.
Why the whimsical shaped sign?
Join the butter dish supremacy. I promise, you’ll like your life more
deleted by creator
Please, you’re ignoring that the very obvious deduction that DNC didn’t want an open primary.
Oh! Thanks for this. It seems like something worth looking into