Made sure the stock firmware printed the example gcode that came on the SD card and then immediately embarked on my journey to get klipper running on this guy.

I didn’t finish until the wee hours this morning so I’ve yet to really give it a go but all the essentials are operational.

Here’s the GitHub link to the config I created: https://github.com/0xD34D/ender3-v3-se-klipper-config

  • hibbfd
    2•10 months ago

    even better, add [screws_tilt_adjust] to take advantage of the crtouch and a little fancy computer math to make leveling super easy.

    after configuring the screw locations and thread pitch, execute the command screws_tilt_calculate

    https://www.klipper3d.org/Manual_Level.html

    ender beds use M4 screws

    • 0xd34dOPEnglish
      2•10 months ago

      I’m going to look into adding this in, thanks for the tip!