• GenderNeutralBro@lemmy.sdf.org
    link
    fedilink
    English
    arrow-up
    6
    ·
    1 year ago

    Can you tell me more about your case and noise insulation? I’ve recently been unhappy with my PC’s noise level and I’m looking for upgrades.

    • It’s the windowless version of the Fractal Design Define R5. The panels are all lined with padding to reduce noise. I have a single Noctua NF-F12 moving air through it. It’s capable of spinning to 2,000 RPM if needed, but it never gets hot enough inside to ever spin faster than 1,200. Even at full speed, the fan is still very tolerably quiet. I only bought the ippc version because it wasn’t brown and brown.

      Also, the CPU is a 4790K cooled by a Noctua NH-U9B SE2. It’s a 92mm cooler that fit nicely in my old “Optimus Prime we have at home” case. It has two fans on it that run at a constant 900 RPM. It does a great job keeping heat in check at stock clock, but I wouldn’t trust it in an overclock situation on this CPU.

      • Rai@lemmy.dbzer0.com
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        4790k, one of the longest living processors out there. Still running one in one of our guest machines!

        I use a Fractal Design Meshify C myself, and a Noctua D15. Whatever the quietest Corsair fans are, got five. It’s completely silent.

        My partner has the same setup, but their machine is quite a bit louder. I think it’s cuz we went with that 35USD ninja… blade… whatever cooler that people recommended for its similar performance to the D15, but 100 less. That thing is quite loud, though.

        Before I redid my machine I was using an AIO, a nice Corsair platinum one, and three LL120s. MF was loud as shit. When the AIO spun up, I had to turn my volume up.

        When I made all of my changes I DID also put a completely unnecessary 1KW Platinum PSU in there, which has a “fan doesn’t run” mode.

    • ultimitchow
      link
      fedilink
      English
      arrow-up
      4
      ·
      1 year ago

      Not OP but I went on my own crusade against noise a few years ago. I had a ryzen 1600 and a 1070 in an NZXT S340 case using the included case fans. I wanted to get rid of noisy components entirely instead of using any kind of sound isolation or insulation because I thought it would be easier to get rid of the problem at the source than to try to hide it. I replaced both case fans with be quiet shadow wings 2s and got a be quiet dark rock 4 to replace the stock CPU cooler. My CPU never used more than 100w but the new cooler was rated for 200w. I thought it would be quieter to have an oversized cooler for my CPU since a bigger cooler would need a slower fan speed to get rid of the same amount of heat as an appropriately sized cooler. I also got a 850w power supply with a mode that turns off the fan completely if it’s using less than 200w. My whole tower used around 300w when playing the games I normally played and around 100w or less while doing light work. I tweaked the fan curves of everything so temps stayed under 50C with light loads and all my fans stayed at about 900rpm. Every fan got faster and louder while gaming but I didn’t notice or care since it was quieter than the sounds and music of the games. After I got all my new fancy fans my 8TB internal HDD became by far the noisiest thing in my whole set up so I built a NAS with hand-me-down hardware and put all my spinning rust storage in a different room. Since then my only upgrades have been a bigger SSD and a ryzen 5800X CPU.

      In the dead of night when the whole house is quiet my own breathing is louder than my PC 2 feet away on the desk if I’m not gaming.