I found an active thread in a sub on another instance I’d like to participate in. When I sub to the thread from sh.itjust.works there are no comments; I assume that’s because sh.itjust.works only starts syncing communities after the first subscription. So now I can either read the thread on an instance I don’t have a login for, or participate in an empty version of the thread on sh.itjust.works.

Is there any way to participate in the active thread at this point? Thanks.

edit: Just checked my subscription to the new community is [pending]. Maybe that’s it?

edit2: Thanks to @Barbarian I can at least sub to one of the pending communities, and the others are on lemmy.ml, so I’ll just wait those out.

  • realcaseyrollins@exploding-heads.comEnglish
    5·
    2 years ago

    I’ve found that the best way to load a post or community is actually to just copy the remote link and search for it. Communities usually take about 30 seconds to load but if you sit in the search results page for a bit it’ll show up.

    But you may want to make sure that your instance isn’t blocked, by going to [instanceurl]/instances

    • Sharp312@lemmy.oneEnglish
      4·
      2 years ago

      Does that get you comments too? In another thread OP said they were trying to access [email protected] and when I go to that community via my instance, i see the posts but no comments. And its obviously been a bit since it started syncing. Our instances arent blocked

      • Wigglehard@exploding-heads.comEnglish
        2·
        2 years ago

        It depends on if that instance has blocked your instance that you made your profile on, i know for example beehaw has blocked exploding heads (for very little reason tbh) so now i can’t comment there but on here i can see your comment and give my two cents