Looking for recommendations on coffee makers. Preferably a drip coffee maker. I’ve been using a percolator for years and while it usually works fine, it doesn’t always brew thoroughly if the water isn’t cold enough.

  • snoons@lemmy.ca
    link
    fedilink
    arrow-up
    9
    ·
    1 year ago

    Consider using a Chemex. If it’s kept away from explosions and impacts with rigid surfaces, it’ll keep ‘working’ until the heat death of the universe. You can even keep using the same filters if they’re the right size.

    • catsarebadpeople
      link
      fedilink
      arrow-up
      4
      ·
      edit-2
      1 year ago

      I really have to second this due a few reasons:

      1. It’s not expensive and will last as long as you don’t break it. It’s made of glass but it seems to be special glass because it’s hard to break. I’ve had two of them over the past 13 years. Broke one after ten years.

      2. Since it’s less expensive you can spend more on a BIFL coffee grinder and hot water pot. I’d suggest DeLonghi for a grinder and the FELLOW goose neck water heater. I’ve had both for many years and love them

      3. The Chemex is easy to clean. After out pour your coffee just rinse it out. Use soap once a week and it’ll not even get stained. Coffee makers end up getting really gross after a while in my experience so even if your coffee maker lasts a long time you’ll want to throw it out because everything that comes out of it tastes burned and extra acidic.

      • snoons@lemmy.ca
        link
        fedilink
        arrow-up
        3
        ·
        1 year ago

        IIRC the glass is borosilicate, which is really the perfect glass for this application.

      • omfgkarlmarx@lemmy.world
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        I would recommend Baratza grinders. They’re easy to repair and they offer just about every part. The motor in my Encore developed a dead spot after like 7 or 8 years and several hundred pounds of coffee. Took less than an hour to replace the motor and upgrade the burr set.

    • LappingDog
      link
      fedilink
      arrow-up
      3
      ·
      1 year ago

      I feel like most pour over cones will work. I use a V60 (the plastic variety) and there’s no way I could foresee it breaking outside of being an idiot.

      • oxjox@lemmy.ml
        link
        fedilink
        English
        arrow-up
        2
        ·
        11 months ago

        I went with a regular gooseneck kettle and an induction cooktop. The cooktop can be used to boil water for pasta, etc. and the kettle is just a metal vessel with a thermometer on top. If the cooktop breaks, I can still boil water on the gas stove top.