I don’t know why this is such a hard combo to meet, but I can’t seem to find anything that suits. I assume there’s enterprise gear that would meet these points, but I’m not sure where to start.
POE is for running a half dozen POE cameras, 3x WIFI6 WAPs, Home Assistant Yellow. I could get away with running a separate POE switch if not for the WAPs (looking at the TP-Link AX11000’s which are 10GbE). I could buy a UniFi XG 6 POE for just the WAPs and use another regular POE switch to give me enough ports, but that’s just getting messy.
The ideal is to have a high density 10GbE managed switch that I can use for both my regular gear and POE gear (I have 20 ports to connect out to plus gear I might run in the rack). If the Unifi XG Enterprise had POE it would be perfect.
Are you requiring a 10Gbe Rj45 switch with PoE? If so, tough call, even for used market. Otherwise, Cisco, Juniper, Aruba, HPE, etc. all have options for you.
This yeah, ideally with at least enough 10GbE copper ports that can do PoE for the WAPs (though more would be good, the house I’m going to end up running them in is being built atm and it’d be nice to have 10GbE available at workstations/etc. I made sure the spec for the house would be fine for 10GbE over copper all over. (Plus a sneaky draw through wire for fibre between the comms rack under the stairs and the 8 car shed at the back of the property that will have my louder gear.)
I know I could always just do 3 switches, 1 x Ubiquiti XG Enterprise (for my regular gear), 1x Ubiquiti XG 6 (for PoE 10GbE copper WIFI6 WAPs) and 1 x regular PoE switch for all the gear that will be 1GbE like the cameras and home assistant yellow/etc but it’s a lot messier than I’d like.