Trying to measure my roleplaying (non-human) character’s weight, lol

  • snooggums@kbin.social
    link
    fedilink
    arrow-up
    4
    ·
    1 year ago

    The other examples about weight for construction are about avoiding long term settling of construction, not a single creatures weight. The overall point about weight per square inch are relevant, but let’s take a simple example.

    Cattle have a lot of weight on four feet that are smaller than a human foot. When they walk, one or two feet will be off the ground, and they don’t sink unless it is muddy. Even then, it isna manner of inches and needs to be really wet. A horse running is putting multiple times their weight down and sideways on the ground and their feet aren’t sinking in unless it is muddy.

    An elephant has a ton of weight but a larger foot. Again, this relatively small footprint per weight does not let them sink into the ground unless muddy.

    So if you are wondering how heavy a human sized character would need to be to sink into dry soil in a noticeable time frame while standing still then the weight would need to be many, many tons.

  • Smuuthbrane
    link
    fedilink
    English
    arrow-up
    3
    ·
    1 year ago

    It’s less about grass and more about the underlying soil. If there’s a small layer of topsoil on top of rock, you’re not sinking. If you’re in a low valley with poor drainage and lots of sand and clay, it’s possible. You’d have to look up what various substrates can take in terms of bearing pressure. From there figure out a character’s mass and foot area, find the pressure they’d exert, and you have your answer as to whether they sink.

    I’m not a civil engineer so I can’t give you any more details than that, sorry.

  • ImplyingImplications@lemmy.ca
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    Depends on the type of soil. This site gives some general estimates:

    Soil capacity is measured in pounds per square foot (psf). The load-bearing capacity of soils range from 4,000 psf for sedimentary rock to as little as 1,500 psf for clay and silt. Soils that are a predominantly sand or gravel typically fall in the middle, from 2,000-3,000 psf. In very few instances are actual soil tests done. Most inspectors will know the approximate soil-carrying capacity in the areas they cover.

  • southsamurai
    link
    fedilink
    arrow-up
    2
    ·
    1 year ago

    Depending on the soil, as little as 135. Our back yard is notorious for being soft and springy, and one of my exes weighed that and would sink in slightly.

    Btw, the average person weighs more than that because they’re average. The question makes more sense if you just ask how much a person has to weigh. It’s hard to find a single, worldwide average for all humans, but the range is from a low of about 130 to a high of about 180, which includes only adults.

    In our yard, I’ve seen a 60lb bag of sand sink in and leave a barely visible depression after a few minutes.

      • southsamurai
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        Pretty much just some foothills loam. Lots of good organic matter, on top of clay.

        On this end of town, we get a lot of runoff, so it stays damp, and I keep things pretty packed with critters by virtue of planting lots of native stuff. So there’s a shit ton of worms aerating, we get chipmunks, voles, and the occasional whistle pig. Squirrels love burying shit too.

        So the top six to eight inches is almost like well churned potting soil. Just this black, rich soil with occasional pebbles.

        • shalafi@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Aw man! I wanna come hang out!

          Can I get a truckload of dirt while I’m there? Soil here is sand with a bit of red clay. Organic layer is only 1-3" deep. Only place I can find the good stuff is at my camp in the swamp where the water occasionally gets high.

    • Damaskox@kbin.socialOP
      link
      fedilink
      arrow-up
      1
      ·
      edit-2
      1 year ago

      Edited the title (question)!

      Er - I also must ask that what weight measure are you using?
      I was looking for kilograms 😅

      • southsamurai
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        Pounds lol. 135 is a looot of kilos, but fairly normal pounds.

        135 works out to 61.12 kilos in my conversion app.

        Rough guesstimate, I’d say someone as little as 50 kilos could sink into our soil, it would just spring back almost immediately. I know my niece doesn’t leave a visible dent even when stomping, and she’s around 40 kilos

        But I’ve been on plenty of grass lawns that didn’t give in under my feet, and I’m about 120 kilos (I’m a hoss, in American terms lol).

        I’ve also been around a couple of guys that were over 400 pounds, about 180 kilos and higher. On typical soil, they didn’t sink in visibly. Even playing football (handegg version), on fields that are fairly loose soil underneath, I never saw anyone actually sink in, just standing. You’ll leave marks when you run, but not just standing.

        However! If you’re talking about something more like fresh tilled soil, I’ve seen my niece sink in to that kind of ground, once nearly to the top of her shoes. Even if you laid sod over soil like that, an adult male of average weight would sink in a good bit before they compressed it enough.

        Hell, last year, we had a gully washer of a storm that flooded the back yard. The paths where I have grass were actually flooded where you couldn’t see the grass at all. The next day, I went out to check for damage, got to the lowest point of the yard and hit a soft spot. Sank in up to my ankles.

        All of which is just to point out that soil condition matters more than weight for what you asked about.

  • perviouslyiner@lemm.ee
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    depends how big their feet are! you’ll estimate the bearing capacity of the soil (e.g. 100kPa), then divide weight by shoe area to get their pressure on the ground.