• radostin04@pawb.social
    link
    fedilink
    arrow-up
    169
    arrow-down
    6
    ·
    1 year ago

    Inaccurate meme - the white and red RCAs in composite typically don’t actually carry the left and right channels - usually, the white one is L+R, meaning both the left and right channels combined into one, and the red one is L-R, the difference between the right and left channels.

    This is done so that a mono television, which will only have a yellow and white port, will still be able to hear both audio channels, as opposed to having to completely miss out on one of them

      • TheRealLinga
        link
        fedilink
        arrow-up
        9
        ·
        1 year ago

        It’s so funny, I had the same reaction! Never quite understood it, just switched plugs until it worked. Then it got phased out and… decades later a meme brings light to my confusing childhood!

    • chinpokomon@lemmy.world
      link
      fedilink
      arrow-up
      11
      ·
      1 year ago

      The video cable does a similar trick with how it supports color. This is why S-Video was superior to composite video until component came along. S-Video split the intensity and color into two signals and then component split the color further into a blue difference and a red difference. If you only wanted black and white, you didn’t need to use the color signals and the image would degrade to a monochrome representation.

      The composite video, with only one video signal wire, was similar to what was received over the antenna, with the broadcast signal separated from the carrier signal and the audio sub bands removed. It was the video signal with the color signal still combined. The progression from Antenna -> Composite -> S-Video -> Component -> DVI-I -> DVI-D -> HDMI -> Display Port has been an interesting one. The changes in the digital realm have been less about the image quality, the digital signal can either be read or not, and more about the bandwidth and how much data can be sent, aka resolution and framerate. Those first four transitions in particular had significant impact on the image quality.

    • rektifier
      link
      fedilink
      arrow-up
      4
      ·
      1 year ago

      This must be BS or a regional thing. All the RCA ports I’ve seen in North America are labeled L and R, not L+R and L-R.

      • radostin04@pawb.social
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        It’s possible that it might only be a thing in PAL regions - I’d try, but I don’t have anything that uses composite to try now.

        • OADINC@feddit.nl
          link
          fedilink
          arrow-up
          2
          ·
          1 year ago

          I can confirm that everything that uses component and L/R that I have used in my life (born in 2001 in the Netherlands, so PAL) has separate L and R channels. I have confirmed this with my multimeter before.

      • Holzkohlen@feddit.de
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        I use those on my speakers and I can flip left/right stereo if I flip the cables. I think that confirms that they don’t have both in one I think.

    • hDGGgrLpg8nEucjxWnJz@lemmy.world
      link
      fedilink
      arrow-up
      2
      ·
      1 year ago

      I appreciate you starting this comment with ‘Inaccurate meme’. I think it should become a thing. Really helps me know to buckle in for something good

  • BudgetBandit
    link
    fedilink
    arrow-up
    36
    ·
    1 year ago

    laughs in european

    I present to you: the Scart.

    Our gaming consoles came with it.

    We were clueless the first time we hooked up our N64 at gran-gran, since the old TV did not have a Scart connector, but we figured out that the Scart’s colored cables go in there.

    • Blackmist@feddit.uk
      link
      fedilink
      English
      arrow-up
      13
      arrow-down
      2
      ·
      1 year ago

      Scart was amazing. RGB, composite, component, audio. All in one cable. Granted that cable and connector were enormous, but one cable nonetheless.

      • BorgDrone@lemmy.one
        link
        fedilink
        arrow-up
        14
        arrow-down
        1
        ·
        1 year ago

        SCART was terrible.

        Theoretically it had all that in one cable, in practice it never did. You’d usually have 3-4 SCART ports on a TV, but not all ports accepted our output the same signals. There was no way to tell from the outside what the output or input from a SCART port so you either had to try different port combinations or look it up in the manual (if you had one). Most TV’s had one port that accepted s-video, on that accepted RGB and they usually accepted composite on all ports.

        Worse, not all cables had all 21 connections. If you were lucky you could tell because not all pins on the connector would be there (but this wasn’t necessary the case).

        Usually there was also one port on a TV that output the video from the tuner. This was used for analog pay TV decoders. You would hook it up to that SCART port and it would get the scrambled video from the TV and return the descrambled video over the same port.

        Also, due to the size and design of the connector it was almost impossible to insert it blindly. Inserting one into the back of one of those enormous CRT television was always a challenge.

  • bighatchester@lemmy.world
    link
    fedilink
    arrow-up
    16
    ·
    1 year ago

    I remember Christmas day getting a ps1 pulling out the cables and realizing that my tv didn’t have the right ports and had to wait a couple of days to play it since the stores where closed and I couldn’t buy one of those cables that connected to where the cable tv goes . Then getting stuck at the first section of tomb raider 2 for the next couple of days …

        • sdoorex@slrpnk.net
          link
          fedilink
          English
          arrow-up
          7
          ·
          1 year ago

          A good way to remember is that RGB on the same wire is a Composite signal whereas when they have their own cables they are sent as individual Components.

          • Hyperi0n@lemmy.film
            link
            fedilink
            English
            arrow-up
            2
            ·
            1 year ago

            Composite is Red, White(Sometimes black) and Yellow.

            The best way to remember is Composite rhymes with shit.

    • ElHexo [comrade/them]@hexbear.net
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      RCA is just the connector, composite video is all the video signal chucked into one cable - component video splits it out into the colour components (getting the signal to that early HD level)

    • stevehobbes@lemmy.world
      link
      fedilink
      arrow-up
      1
      arrow-down
      3
      ·
      edit-2
      1 year ago

      This is RCA (the left / right audio) and composite video.

      This meme would have been better with component video and TOSLINK or S-Video and toslink.

      • pitninja@lemmy.pit.ninja
        link
        fedilink
        English
        arrow-up
        8
        ·
        1 year ago

        I don’t see how this meme would be better with an audio cable that doesn’t have a separate physical signal path for left and right channels. The Van Gogh panel wouldn’t make any sense.