I found an active thread in a sub on another instance I’d like to participate in. When I sub to the thread from sh.itjust.works there are no comments; I assume that’s because sh.itjust.works only starts syncing communities after the first subscription. So now I can either read the thread on an instance I don’t have a login for, or participate in an empty version of the thread on sh.itjust.works.

Is there any way to participate in the active thread at this point? Thanks.

edit: Just checked my subscription to the new community is [pending]. Maybe that’s it?

edit2: Thanks to @Barbarian I can at least sub to one of the pending communities, and the others are on lemmy.ml, so I’ll just wait those out.

    • Sisyphus OP
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      Can you walk me through how to do it? As it is, I can only see a thread on a community I’m not subscribed to by going to the instance it’s hosted on. But I’m not logged in there.

      • Sharp312@lemmy.one
        link
        fedilink
        English
        arrow-up
        5
        ·
        1 year ago

        While you wait for sh.itjust.works to sync all the comments, you can browse it on the other communities instance, find the comment you want to interact with, then right click the little rainbow icon next to the hyperlink icon, copy that link into sh.itjust.works’ search bar and it will sync that comment immediately, letting you interact with it.

        For example, if I found your comment on another instance and I wanted to reply, I would copy the link to it, go to my instance (lemmy.one) and paste the link which is: https://sh.itjust.works/comment/120320

        Hacky solution ik but itll work until the user experience kinks are ironed out.

        • realcaseyrollins@exploding-heads.com
          link
          fedilink
          English
          arrow-up
          5
          ·
          1 year ago

          I’ve found that the best way to load a post or community is actually to just copy the remote link and search for it. Communities usually take about 30 seconds to load but if you sit in the search results page for a bit it’ll show up.

          But you may want to make sure that your instance isn’t blocked, by going to [instanceurl]/instances

          • Sharp312@lemmy.one
            link
            fedilink
            English
            arrow-up
            4
            ·
            1 year ago

            Does that get you comments too? In another thread OP said they were trying to access [email protected] and when I go to that community via my instance, i see the posts but no comments. And its obviously been a bit since it started syncing. Our instances arent blocked

            • Wigglehard@exploding-heads.com
              link
              fedilink
              English
              arrow-up
              2
              ·
              1 year ago

              It depends on if that instance has blocked your instance that you made your profile on, i know for example beehaw has blocked exploding heads (for very little reason tbh) so now i can’t comment there but on here i can see your comment and give my two cents

        • Sisyphus OP
          link
          fedilink
          English
          arrow-up
          3
          ·
          1 year ago

          Oh, hey, that’s cool! I knew the “network” icon was a direct link, but didn’t know searching for it on my instance would sync it. Super cool.